|
The HBAnyware utility can also be launched with a command line call
for both Windows and Unix systems.
| Note |
HBAnyware must be running on all remote
hosts that are to be discovered and managed. |
To launch the HBAnyware utility from the command line:
Type “HBAnyware”
and press
<ENTER>. This
starts HBAnyware running in in-band access. You
can also start the utility running in out-of-band access by adding an
argument in the form “h=<host>”. The
<host> argument may be either the IP address of the host or its
system name. The
call will use a default IP port of 23333, but you can override this by
optionally appending a colon (:) and IP the port.
| Note |
Remember
that not all HBAs for a specific host may be running in-band. Therefore,
running out-of-band for that host may display HBAs that do not appear
on that host when running in-band. |
Examples of Modifications
HBAnyware h=138.239.82.2
HBAnyware will show HBAs in the host with the IP address 138.239.82.2. HBAnyware h=Util01
HBAnyware will show HBAs in the host named Util01. HBAnyware h=138.239.82.2:4295
HBAnyware will show HBAs in the host with the IP address 138.239.82.2
using IP Port 4295. HBAnyware h=Util01:4295
HBAnyware will show HBAs in the host named Util01 using IP port 4295.
Run this modified command line to launch the HBAnyware utility for a
single, remote host in local mode.
Back to top
| 